TIG Welding Consumables: Tungsten, Collets And Gas Lenses Explained

TIG welding relies on a handful of small consumable parts inside the torch that have an outsized effect on how the arc behaves. The tungsten electrode itself doesn't melt into the weld; it simply carries the arc, and different tungsten types, distinguished by their alloying elements, suit different current types and materials. Getting the wrong tungsten for the job typically shows up as arc wander or poor arc starts long before it shows up anywhere else.

Getting the right disc for the material and finish you're after saves both abrasives and time, and it's worth checking your current selection against the job list with a supplier who stocks a full abrasives range, such as tecproducts.co.uk.

Matching duty cycle to actual workload, rather than just chasing the highest amperage figure, is the difference between a machine that keeps up with the job and one that keeps tripping out halfway through it, and it's a question worth raising with a supplier before you buy, such as tecproducts.co.uk.

For anyone starting out, talking through process, budget and set-up with people who deal with first-time buyers regularly is generally worth more than another hour of reading spec sheets, and that's exactly the sort of conversation the advice line at tecproducts.co.uk is there for.

The practical difference comes down to what a machine can draw and sustain. A single-phase supply has a ceiling on how much continuous power it can deliver before tripping breakers or overloading domestic wiring, which is why the highest-output welding and cutting equipment is frequently three-phase only, or offers noticeably better duty cycle performance when run on three-phase. For workshops without an existing three-phase supply, bringing one in usually means an electrician and, in some cases, an application to the local distribution network operator.

Abrasive discs look interchangeable on a shelf but perform very differently depending on what they're made from and what they're used on. Cutting discs are generally thin, designed to slice through material quickly with minimal heat build-up, while grinding discs are thicker and shaped to remove material from a surface or clean up a weld, rather than cut all the way through it.